Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
4.
Remove the five (5) EVAP canister assembly mounting bolts. See Figure 4.
5.
Position the EVAP canister so you can access and disconnect the vapor hose from the passenger side of the EVAP canister, then the vent solenoid
electrical connector, the wiring harness pin-type retainer and the vapor hose from the driver side of the EVAP canister. Once all the items are
disconnected, remove the EVAP canister from the vehicle. See Figure 5.
6.
Connect the vapor hose, wiring harness pin-type retainer and the vent solenoid electrical connector to the driver side of the new EVAP canister.
Then connect the vapor hose to the passenger side of new EVAP canister.
7.
Install the five (5) canister assembly mounting bolts. Tighten the bolts to 10 Nm (89 lb-in).
8.
Lower the vehicle.
9.
Position and raise the spare tire.
10.
Connect the battery negative cable.
11.
Perform an Evaporative Emissions System Leak Test as follows:
a)
CAUTION: The evaporative emission system must not be pressurized to more than 3.48 kPa (1.03 in Hg) or damage to the evaporative
