Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
Mark the rear driveshaft.
3. Remove the rear driveshaft.
1
Remove the rear driveshaft bolts.
2
Remove the rear driveshaft.
4. Using the special tools, remove the extension housing seal.
5. CAUTION: Use the extension housing bushing remover carefully so that the seal area is not damaged.
Using the special tool, remove the extension housing bushing.
Installation
1. CAUTION: The lube hole in the extension housing bushing must be aligned with the lube groove in the extension housing. This groove is located
at the 3 o'clock position when viewed from the rear.
NOTE: Inspect the counterbore of the extension housing for burrs. Remove any burrs from the extension housing counterbore with an oil stone.
