Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
5. Position aside the water shield.
6. Connect the power window switch.
7. Remove the rear door window glass rivets.
^
Lower the glass approximately two-inches to access the rivets through the holes.
8. Carefully lower the window regulator while holding the glass.
^
Lower the glass.
9. Separate the front of the window run/weatherstrip from the door.
10. Remove the rear door window glass through the outboard side of the rear door.
INSTALLATION
1. To install, reverse the removal procedure.
^
Use the special tool to install the rivets.