Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
NOTE: Lubricate the urethane adhesive with water to aid the special tool when cutting.
12. Using the special tool, distance the windshield from the body.
13. Using the special tool, cut the remaining urethane adhesive and remove the windshield glass.
14. Using a soft brush or vacuum, remove any foreign material or dirt from the pinch weld.
INSTALLATION
CAUTION: After installing the urethane installed glass, the vehicle should not be driven until the urethane adhesive has cured. The curing times at
temperatures above 13°C (55°F) and relative humidity above 50% is 12-24 hours (refer to Essex Drive Away Chart for cure times, as temperatures and
humidity vary). Inadequate curing of the urethane adhesive may adversely affect the strength of the urethane bond.
1. Dry fit the windshield. Make alignment marks with tape or non-staining grease pencil.
2. Trim the remaining urethane adhesive on the pinch weld to within the specification.
^
The existing urethane adhesive surface should be smooth and free of cuts and contamination.
CAUTION: Do not scratch the pinch weld area.
3. Use a wool applicator to apply Urethane Metal Primer Essex U-413 meeting Ford specification WSB-M2G234-C to any exposed metal on the
pinch weld. Allow six to ten minutes to dry.
