Explorer Sport Trac 2WD V6-4.0L VIN K (2007)
4. CAUTION: Use care when separating the seat back trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn
from the backrest foam pad.
Release the backrest trim cover lower J-clip, hook-and-loop strips and invert the trim cover to the first row of hog rings.
5. Remove the one-way push clip on the side of the inboard power recliner. Slide the recliner shaft out from the outboard side of the seat enough to
clear the inboard recliner and power recline motor.
6. Disconnect the electrical connector, remove the screw and the power recline motor.
Installation
1. NOTE: The recliners are synchronized. Do not rotate the recliner shaft until completely installed.
Install the recliner motor.
1. Position the recliner shaft through the recliner motor and inboard recliner.
2. Install a new one-way push clip onto the recliner shaft at the inboard power recliner.
3. Turn the recliner motor so the recliner motor mounting hole lines up with the screw hole in the inboard power recliner.
4. Install the recliner motor bolt.
5. Connect the recliner motor electrical connector.
2. Roll the backrest trim cover down, attach the hook-and-loop strips and connect the backrest trim cover lower J-clip.
3. Position the backrest trim cover to the inboard and outboard recliners and install the plastic rivets.
4. Install the front seat backrest.
5. Install the front seat and repower the SRS.
