Explorer Sport Trac 2WD V6-4.0L VIN K (2007)
5. Slide the side air bag module onto the backrest frame so the bracket hook wraps around the backrest frame.
6. Install the side air bag module bolts, route the wire harness as noted during disassembly and install the side air bag module wire harness pin-type
retainers.
-
Tighten to 10 Nm (89 lb-in).
Heated seat
7. If necessary, install the backrest heated seat mat.
-
For driver seats with power recline, connect the backrest heated seat mat electrical connector.
All seats
8. Position the backrest foam pad around the backrest frame.
9. Position the backrest trim cover to the backrest frame and foam pad.
10. Roll the backrest trim cover down, attach the hook-and-loop strips and install the second row of hog rings.
11. Roll the backrest trim cover down, attach the hook-and-loop strips and install the first row of hog rings.
12. Roll the backrest trim cover down, attach the hook-and-loop strips and connect the backrest trim cover lower J-clip.
13. Position the backrest trim cover to the inboard and outboard recliners and install the plastic rivets.
14. NOTE: The head restraint guides are not interchangeable.
Install the head restraint guides.
15. Install the head restraint.
16. Install the front seat backrest.
17. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
