Explorer Sport Trac 2WD V6-4.0L VIN K (2007)
3. Using an appropriate tool, push in the hole of each head restraint guide while lifting up and remove the head restraint.
4. NOTE:
-
The inboard and outboard head restraint sleeves are not interchangeable.
-
The head restraint sleeves incorporate an alignment tab that must face forward when installed.
Squeeze together the tip of the head restraint sleeve and pull the sleeve out of the frame tube.
5. Pull at the bottom and remove the safety belt guide cover.
6. CAUTION: Use care when separating the seat back trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn
from the backrest foam pad.
Separate the hook-and-loop fasteners, invert the backrest trim cover and remove the hog rings. Remove the backrest trim cover.
-
Feed the safety belt out through the backrest trim cover.
7. Remove the backrest foam pad.
8. Remove the safety belt retractor cover.
9. Remove the bolt and the safety belt retractor.
-
To install, tighten to 75 Nm (55 lb-ft).
10. To assemble, reverse the disassembly procedure.
Seat Backrest - Second Row, Bucket
SEAT BACKREST - SECOND ROW, BUCKET
