Explorer Sport Trac 2WD V6-4.0L VIN K (2007)
3. NOTE: Note the position of the 2 rear moonroof drain hose routing clips for installation.
Disconnect the rear moonroof drain tube and detach the 2 rear moonroof drain hose routing clips.
All vehicles
4. Disconnect the safety canopy module electrical connector and detach the connector pin-type retainer from the C-pillar.
5. NOTE: Note the locator tab on the front tether anchor bracket to the A-pillar sheet metal for installation.
Remove the bolt and the front tether anchor bracket.
6. Detach the 3 safety canopy module front tether pin-type retainers from the A-pillar.
7. Remove the 3 front bolts from the safety canopy module.
8. Remove the 2 rear bracket bolts from the safety canopy module.
9. Remove the 2 bolts and the safety canopy module C-pillar tether bracket.
10. Remove the 2 safety canopy module bolts near the C-pillar.
11. Gently lift the safety canopy module up and inward at the B-pillar to release the bracket hook from the sheet metal.
12. Move the safety canopy module forward to release the rear bracket hook from the sheet metal and remove the safety canopy module.
Installation
WARNING:
-
Before installing a safety canopy module, inspect the roof line for any damage. If necessary, the sheet metal must be reworked to its
original condition and structural integrity. All damaged fasteners must be installed new and any foreign material removed. Failure to do
so may result in personal injury in the event of a safety canopy deployment.
