Explorer Sport Trac 2WD V6-4.0L VIN K (2007)
CAUTION: Orientation of the suspension fasteners is important. Make sure the fasteners are installed in the same direction as they were in
when removed.
1. Remove both upper arms.
2. NOTE: Removal of the LH shock absorber lower bolt will allow more movement of the wheel knuckle when installing the stabilizer bar.
Remove the LH shock absorber lower bolt.
3. Disconnect the purge solenoid electrical connector.
4. Unclip the wiring harness from the frame.
5. Remove the fuel tank filler pipe bracket bolt.
^
To install, tighten to 15 Nm (11 ft. lbs.)
6. Loosen the fuel tank filler pipe hose clamps and disconnect the hose.
^
To install, tighten to 3 Nm (27 inch lbs.)
