Explorer Sport Trac 2WD V6-4.0L VIN K (2007)
^
Clean and deburr the cut end of the steel tube.
5. NOTE: Be sure the cooler tube is fully seated in the body of the fitting before final tightening of the ferrule nut.
Install the tubing ferrule hose assembly connector onto the end of the steel fluid cooler tube. Finger-tighten the ferrule nut, then tighten the nut an
additional 1-1/2 turns to seat the ferrule in the connector.
6. Remove the section of the rubber hose as illustrated.
7. CAUTION: The filter has a bypass valve in it. The red arrow on the filter indicates the direction of fluid flow through the filter. The
filter must be installed in the fluid cooler return line with the red arrow on the filter pointing away from the transmission fluid cooler and
toward the transmission (the return line has fluid coming out of the cooler going to the transmission). If the fluid filter is not installed
correctly, it will cause internal transmission damage.
CAUTION: Do not install any rubber hoses or steel tubing with a bend entering the filter greater than 60°.
Install the one end of the filter into the rubber hose with a clamp.
^
Tighten the hose clamp.
8. Using a suitable length of hose, install the other end of the filter into the tubing ferrule hose assembly with 2 clamps.
^
Tighten the hose clamps.
