Explorer Sport Trac 2WD V8-4.6L (2008)
7
Separate the cushion trim cover elastic strap from the cushion side shield.
-
If equipped with a manual seat track, remove the cushion side shield.
8
If equipped with power seats, remove the seat control switch knob and separate the seat control switch from the cushion side shield.
-
Remove the cushion side shield.
3. Release the cushion trim cover rear J-clips.
1
Release the cushion trim cover rear inboard J-clip from the inboard recliner.
2
For a driver seat or passenger seat equipped with heat, release the cushion trim cover rear J-clips.
4. Release the cushion trim cover inboard J-clip.
5. Remove the safety belt buckle and pretensioner electrical connector cover.
6. Remove the 2 safety belt buckle and pretensioner nuts.
-
To install, tighten to 36 Nm (27 lb-ft).
7. Disconnect the safety belt buckle and pretensioner electrical connector and safety belt buckle switch electrical connector.
-
Remove the safety belt buckle and pretensioner.
Seat with manual lumbar
8. Release the cushion trim cover front J-clip. Raise the cushion foam pad and release the lumbar cable pin-type retainer.
9. Remove the 2 screws and separate the manual lumbar control from the cushion frame.
10. Remove the cable from the manual lumbar control.
Driver seat with power recline
11. Disconnect the backrest power feed electrical connector and route out the wire harness.
-
Release any wire harness retainers.
Passenger seat with heat
