Explorer Sport Trac 2WD V8-4.6L (2008)
11. Using the scan tool verify that the transmission fluid temperature is between 80° C-85° C (175° F-185° F). The transmission fluid level must be at
the upper level of the crosshatch mark.
12. NOTE: If the transmission fluid is not at the correct level, follow the steps for Adding Additional Transmission Fluid or Removing Transmission
Fluid in this procedure.
Install the transmission fluid fill plug.
^
Tighten to 35 Nm (26 lb-ft).
Adding Additional Transmission Fluid
NOTE: To get an accurate transmission fluid level reading the engine should be idling (600-750 rpm) in PARK.
1. Install the special tool into the transmission fluid fill hole.
