Explorer Sport Trac 2WD V8-4.6L (2008)
-
Discard the O-ring seal.
-
To install, tighten to 8 Nm (71 lb-in).
9. NOTE: The LH clip should be disconnected from the line. The RH clip should be disconnected from the cooling module.
Detach the 2 compressor-to-condenser discharge line clips at the cooling module.
10. Remove the compressor-to-condenser discharge line.
11. To install, reverse the removal procedure.
-
Install a new gasket seal and O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
12. Evacuate, leak test and charge the refrigerant system.
Condenser To Evaporator Line
CONDENSER TO EVAPORATOR LINE
Removal and Installation
All vehicles
1. Remove the air cleaner (ACL) and ACL outlet tube.
2. Recover the refrigerant.
3. Remove the PCM and PCM bracket.
4. Disconnect the RH wheel speed sensor electrical connector and detach the wire harness from the condenser-to-evaporator line bracket.
