Explorer Sport Trac 2WD V8-4.6L (2008)
Installation
All vehicles
1. Inspect the O-ring seal for damage. Install a new seal if damaged. Lubricate the O-ring seal with petroleum jelly to prevent damage to the O-ring
seal.
1
Install the TSS sensor into the transmission.
2
Tighten the TSS sensor screw.
^
Tighten to 14 Nm (10 lb-ft).
2. Connect the TSS sensor electrical connector.
3. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever
cable end is snapped onto the ball stud. Press the selector lever cable into the selector lever cable bracket and listen for the selector lever cable to
click in place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket. Also make sure that the
selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable
end is correctly installed.
Install the selector lever cable and selector lever bracket.
^
Tighten to 40 Nm (30 lb-ft).