Explorer Sport Trac 2WD V8-4.6L (2008)
Passenger Seat Cushion (Part 2)
Special Tool(s)
Special Tool(s)
Removal and Installation
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. Remove the front seat.
2. Remove the cushion side shield in the following sequence.
1
If equipped, remove the clip and manual recline handle.
2
If equipped, pull and remove the manual lumbar control knob.
3
Remove the scrivet.
4
Release the cushion side shield front clip.
5
From under the cushion side shield, release the 3 hook retainers.
6
Pull out on the cushion side shield at the back and release the pin-type retainer.
7
Separate the cushion trim cover elastic strap from the cushion side shield.
8
Remove the seat control switch knob and separate the seat control switch from the cushion side shield.
-
Remove the cushion side shield.
3. Disconnect and remove the seat control switch.
4. To install, reverse the removal procedure.
5. Install the front seat. If a passenger seat has been serviced, do not prove out the SRS at this time.
