Explorer Sport Trac 2WD V8-4.6L (2008)
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. Depower the SRS.
2. Remove the 4 pin-type retainers and the lower radiator air deflector.
3. Disconnect the electrical connector.
4. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque.
Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
NOTE: Make sure the radiator support and front impact severity sensor mating surfaces are clean and free of foreign material.
Remove the bolt and sensor.
-
To install, tighten to 12 Nm (9 lb-ft).
5. To install, reverse the removal procedure.
6. Repower the SRS.
