Explorer Sport Trac 2WD V8-4.6L (2008)
2. CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
Remove the bolts and position the caliper, pads and anchor plate assembly aside.
^
Discard the bolts.
^
Support the caliper and anchor plate assembly using mechanic's wire.
^
To install, tighten to 165 Nm (122 lb-ft).
3. Remove the brake disc.
4. NOTE: Inspect and if necessary, clean area around wheel speed sensor before removing it from the wheel bearing and hub.
Remove the wheel speed sensor bolt and disconnect the wheel speed sensor from the wheel bearing and hub assembly.
^
To install, tighten to 18 Nm (13 lb-ft).
5. Remove the 3 bolts and the wheel bearing and wheel hub.
^
Discard the bolts.
^
To install, tighten to 122 Nm (90 lb-ft).
6. To install, reverse the removal procedure.