Explorer Sport Trac 2WD V8-4.6L (2008)
1
Align the manual valve and control lever linkage.
10. Tighten the mechatronic bolts in the sequence shown.
^
Tighten to 6 Nm (53 lb-inch).
11. CAUTION: Do not touch the electrical connector pins. Electrostatic discharge may occur and will cause damage to the mechatronic unit.
With the release tab down and unlocked, push the outer shell of the bulkhead electrical connector into the transmission. Make sure that the
bulkhead connector is fully seated into the TCM.
12. Press up on the tab and lock the outer shell of the bulkhead electrical connector in place.
