Explorer Sport Trac 2WD V8-4.6L (2008)
6. Install the reverse servo assembly. Tighten the reverse servo assembly screws in 2 stages, in the sequence shown.
^
Stage 1: Tighten to 5 Nm (44 lb-inch).
^
Stage 2: Tighten to 11 Nm (8 lb-ft).
7. Install new O-ring seals on the transmission control solenoid body connector. Lubricate the O-ring seals with clean transmission fluid.
8. CAUTION: Inspect the transmission case bore to make sure it is free of foreign material and not damaged. If it is damaged, transmission
leak may occur.
Install the transmission control solenoid body. Tighten the transmission control solenoid body screws in the sequence shown.
^
Tighten to 8 Nm (71 lb-inch).
