Explorer Sport Trac 2WD V8-4.6L (2008)
4.0L engine
4. NOTE: After removing the driveshaft, without rotating the driveshaft, place an index mark on the transmission output shaft that matches the
transmission extension housing mark.
Index-mark the driveshaft and the extension housing.
4.6L engine
5. Index-mark the front U-joint flange to the transmission output flange.
6. Remove and discard the 4 driveshaft flange bolts from the transmission output shaft flange.
^
To install, tighten the 4 new bolts to 112 Nm (83 lb-ft).
