Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
Trunk / Liftgate Latch: Service and Repair
Liftgate Latch
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the liftgate trim panel.
3. Remove the air escape vent panel.
1
Remove the pin-type retainers.
2
Remove the air escape vent panel.
4. Remove the watershield.
5. Disconnect the liftgate latch release rod from the liftgate latch remote control.
1
Open the clip.
2
Disconnect the liftgate latch release rod.
6. Remove the liftgate latch.
1
Remove the bolts.
2
Disconnect the electrical connector.
3
Remove the liftgate latch and the liftgate release rod.
INSTALLATION
1. To install, reverse the removal procedure.
-
If necessary, use Multi-Purpose Grease Spray F5AZ-19G209-AA or equivalent meeting Ford specification ESR-M1C159-A to lubricate the
latches.
NOTE:
-
If installation of a new liftgate latch release rod is necessary, be sure to match the color coded rods for correct installation.