Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner system is being serviced, the supplemental restraint system (SRS)
must be depowered.
1.
NOTE: Only use the method described to distinguish between driver seatback frame types. Trim and accessories may vary from one seat to
another of the same frame configuration.
Identify the type of seat back frame by slightly lifting the outside rear corner of the seat back cover and viewing the frame itself. Be sure to procure
the proper kit based on the type of seat back frame.
2.
NOTE: Go to Step 7 if the vehicle is not equipped with side air bags. Record the preset radio stations.
3.
Position the driver seat to its full-forward position.
4.
Turn the ignition switch from RUN to OFF.
5.
Remove the fuse box cover from the left side of the instrument panel near the driver door hinge area and then remove the applicable airbag fuse.
Refer to the following chart to determine which fuse must be removed when working on a vehicle with side air bags.
6.
Disconnect the battery negative cable and wait one minute.
7.
Position the driver seatback to Its full4orward position.
8.
CAUTION: Take care not to damage the seatback trim cover during this step.
Unhook the seatback trim cover J-clip. See Figure 4.
