Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
8. Remove the restraint system diagnostic tool from the driver seat side air bag floor electrical connector.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
9. Connect the driver seat side air bag and power seat (if equipped) electrical connectors.
1
Connect the driver seat power seat track electrical connector.
2
Connect the driver seat side air bag electrical connector.
3
Tie-strap the wire harness.
10. Connect the battery ground cable.
11. Position the driver seat rearward.
12. With the restraint system diagnostic tools still in place at the remaining deployable devices, prove out the air bag system.
13. Tighten in the sequence shown the driver seat front track to floor bolts.
1
Tighten the front inboard bolt.
2
Tighten the front outboard bolt.
14. Move and tilt the driver seat to its highest and most forward position.
