Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
for easier installation of the upper intake manifold.
7.
Position the upper intake manifold carefully, slide the manifold onto the EGR tube and connect both right and left VMV hoses. Also, be sure to
route the IAC valve connector into position.
8.
Install the upper intake manifold screws. Tighten the screws to 7 Nm (62 lb-in).
9.
Connect the IAC valve and TPS connector.
10.
Install the EVR/VIS solenoid bracket. Tighten the screws to 3 Nm (26 lb-in).
11.
Connect the following vacuum hoses:
^
Brake booster.
^
Intake manifold tuning valve (IMTV) servo, if equipped.
^
Right side upper intake vacuum supply (two hoses).
^
PCV valve.
12.
Install the air cleaner outlet tube, and connect the fresh air tubes and IAT sensor.
13.
Correctly route and secure the accelerator and speed control cables. Tighten the screws to 3 Nm (26 lb-in).
14.
Install the accelerator control splash shield.
15.
Start the engine and check for correct operation. Check and top off the cooling system as needed.