Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
1.
Disconnect the engine coolant temperature (ECT) sensor and the engine coolant temperature sender. Position the wiring harness connectors away
from the oil galley plug area. See Figure 5.
CAUTION:
Damage to the oil galley plug will occur if the Torx(R) bit is not fully seated. Use a hand impact driver and an extension, striking the driver firmly, to
loosen the plug.
2.
Remove the oil galley plug. See Figure 5.
3.
Install the volume reduction plug into the oil galley. See Figure 6.
CAUTION:
