Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
connectors.
^
Diagnostics or repairs are not to be performed on a side airbag system and/or a safety belt pretensioner (if equipped) system with the seats in
the vehicle. Prior to attempting to diagnose/repair the side airbag system and/or a safety belt pretensioner (if equipped) system the seats must
be removed from the vehicle and the restraint system diagnostic tools must be installed in the side airbag and the safety belt pretensioner (if
equipped) connectors at the floor connectors. The restraint system diagnostic tools must be removed prior to operating the vehicle over the
road.
^
Diagnostics may be performed on seat systems other than the side airbag or the safety belt pretensioner (if equipped) system (lumbar, climate
controlled, heated, power seat track) with the seat installed in the vehicle as long as the restraint system diagnostic tools are installed under the
seats in the side airbag and safety belt pretensioner to floor connectors.
^
After diagnosing/repairing a seat system the restraint system diagnostic tools must be removed before operating the vehicle over the road.
2. Tighten the right-hand side RCM bolts to specification.
WARNING: THE TIGHTENING TORQUE OF THE RESTRAINTS CONTROL MODULE (RCM) RETAINING BOLTS IS
CRITICAL FOR PROPER SYSTEM OPERATION.
3. Connect the RCM.
1
Tighten the bolt to specification.
2
Connect the RCM electrical connectors.
3
Slide and engage the RCM electrical connector locking clips.
WARNING: THE TIGHTENING TORQUE OF THE RESTRAINTS CONTROL MODULE (RCM) RETAINING BOLTS IS
CRITICAL FOR PROPER SYSTEM OPERATION.
4. Connect the battery ground cable.
5. With the restraint system diagnostic tools still installed at all deployable devices, prove out the air bag system.
