Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
24. Position the driver air bag module to the steering wheel.
1
Connect the driver air bag module electrical connector.
2
Position the driver air bag module to the steering wheel.
25. Install the two driver air bag module retaining bolts.
26. Install the two steering wheel back cover plugs.
27. Remove the restraint system diagnostic tool from the vehicle harness side of the passenger air bag electrical connector.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
28. Install the passenger air bag module.
29. Connect the battery ground cable.
30. Move and tilt the front seats to their highest and most forward position.
