Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
8. Position the side air bag shield to the seat backrest frame.
1
Apply new duct tape to the side air bag shield.
2
Position the side air bag module wire harness so that it will fit loosely between the side air bag shield and the mounting bracket.
3
Position the side air bag shield to the seat backrest frame keeping it in place with the tape.
^
Check that the side air bag module wire harness fits loosely between the side air bag shield and the mounting bracket and is not pinched.
9. Route the side air bag wire harness and install the pin-type retainers to the seat back frame.
10. Unroll the seat back trim cover, to position the deployment chute around the side air bag module.
