Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
17. Install new hog rings onto the swing rods (one shown).
18. Pull the seat back rest trim cover completely down and connect the hook and loop fastener to the seat back cushion.
19. Reattach the seat back trim cover lower J-clips.
20. Position the seat back to the seat bottom and route the wires and cables.
1
Position the seat back to the seat bottom.
2
Pull the side air bag module wire harness through the seat bottom.
3
Pull the lumbar support cable through the seat bottom.
21. Align the seat back to the seat bottom. Install the bolt and tighten to specification.
CAUTION: When positioning the seat or installing the bottom to the seat back, be careful not to damage the seat back pivot and any of the wires
or cables from the seat back to the seat bottom. This can cause damage to one of the seat components.
