Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
NOTE: Clamp the safety belt buckle support assembly collar in a vise along the break line only.
INSTALLATION
WARNING: ALL SAFETY BELT ASSEMBLIES INCLUDING RETRACTORS, BUCKLES, FRONT SEAT BELT BUCKLE SUPPORT
ASSEMBLIES (SLIDE BAR), SHOULDER BELT HEIGHT ADJUSTERS (IF SO EQUIPPED) CHILD SAFETY SEAT TETHER
ATTACHMENTS AND ATTACHING HARDWARE SHOULD BE INSPECTED AFTER ANY COLLISION. ALL BELT ASSEMBLIES
SHOULD BE REPLACED UNLESS A QUALIFIED TECHNICIAN FINDS THE ASSEMBLIES SHOW NO DAMAGE AND OPERATE
PROPERLY. BELT ASSEMBLIES NOT IN USE DURING A COLLISION SHOULD ALSO BE INSPECTED AND REPLACED IF EITHER
DAMAGE OR IMPROPER OPERATION IS NOTED.
1. Install the safety belt buckle onto the safety belt buckle support assembly.
1
Position the safety belt buckle onto the safety belt buckle support assembly.
2
Using the special tool, install the safety belt buckle bolt.
3
Remove the safety belt buckle support assembly from the vise.
2. Install the safety belt buckle support assembly onto the seat.
1
Position the safety belt buckle support assembly to the seat.
2
Install the nut and bolt.
3. Install the front driver or passenger seat into the vehicle.
4. Check the restraint system for correct operation.
