Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
17. Connect the driver seat side air bag electrical connector and tie-strap the wire harness.
18. Connect the battery ground cable.
19. Position the front seats rearward.
20. Disconnect the battery ground cable and wait at least one minute.
21. Remove the restraint system diagnostic tool from the vehicle harness side of the air bag sliding contact electrical connector.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE CAN RESULT IN INJURY AND POSSIBLE VIOLATION OF VEHICLE
SAFETY STANDARDS.
22. Connect the air bag sliding contact electrical connector at the base of the steering column.
23. Position the lower steering column opening finish panel reinforcement and install the bolts.
