Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
3. Install the tie-rod end castellated nut.
1
Position the tie-rod end.
2
Install the tie-rod end castellated nut.
3
Install a new cotter pin.
4. CAUTION: The torsion bar adjustment bolt is coated with dry adhesive. A new bolt must be installed if it is backed off or removed. Failure to do
so can cause the adjustment bolt to loosen during operation and result in a loss of vehicle alignment.
Preload the torsion bar.
1
Tighten the Torsion Bar Tool until the new adjustment bolt and nut can be installed.
2
Turn the adjustment bolt until preliminary adjustment marks are aligned.
5. Remove the Torsion Bar Tool and adapters.
6. Install the torsion bar cover plate.
1
Position the torsion bar cover plate.
2
Install the retaining bolts.
7. Install the wheel hub.
8. Install the anti-lock sensor wire bracket bolt.