Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
Loosen the nut and position the heat shield out of the way.
8. Remove the front band locknut and unscrew the front band adjusting screw.
^
Discard the front band locknut after removal.
9. CAUTION: The servo cover is under spring pressure.
Using the special tool, remove the front band servo cover retaining ring.
^
Slowly remove tension on the J-hook nut and remove the servo cover compressor.
10. CAUTION: The special tool should be used to prevent damage to servo and bore.
Using the special tool, remove the front band servo cover, servo piston and servo piston spring.
^
Insert the special tool into the transmission case, locate on servo rod, and remove the front band servo cover, servo piston and servo piston
spring.
Installation
