Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
Differential Axle Housing: Service and Repair
Axle Housing
Removal and Installation
1. NOTE: Make sure the parking brake control is fully released.
Release the tension on the front parking brake cable and conduit.
1. Pull on the front parking brake cable and conduit until the parking brake pedal moves.
2. Insert a suitable retainer, such as a 5/32-inch drill bit, into the parking brake control to hold it in place so that the front parking brake cable and
conduit stays slack.
2. Raise and support the vehicle.
3. Remove the axle shafts.
4. Mark the driveshaft flange and pinion flange for correct alignment during installation.
5. CAUTION: The driveshaft centering socket yoke fits tightly on the rear pinion flange pilot. Never hammer on the driveshaft or any of its
components to disconnect the yoke from the flange. Pry only in the area shown with a suitable tool to disconnect the yoke from the flange.
