Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
The message center information can be selected through the TRIP/RESET button (base cluster) and by the INFO, SETUP, and RESET buttons (high
series cluster).
Information Displays (Base Instrument Cluster)
The information displays are non-timed modes. The selected mode remains on until the driver presses a message center switch to change the mode, or
until it is overridden by another mode. The information display modes are:
-
Odometer/trip odometer, compass headings
-
Distance to empty
-
Average fuel economy
-
Setup menu
Information Displays (High Series Instrument Cluster)
The information displays are non-timed modes. The selected mode remains on until the driver presses a message center switch to change the mode, or
until it is overridden by another mode. The information display modes are:
-
Odometer/trip odometer, compass headings, outside air temperature display (with dual electronic automatic temperature control)
-
Distance to empty
-
Average fuel economy
-
Instantaneous fuel economy
-
Fuel used
-
Trip elapsed drive time
-
Blank
Setup Displays (Base Instrument Cluster)
The setup displays are timed modes and terminate after a finite interval. Press the TRIP/RESET button to scroll through the SETUP MENU display
sequence. If the TRIP/RESET button is not pressed within 4 seconds, the message center returns to the INFO MENU. The setup display modes are:
-
AWD lock (vehicles equipped with traction control with roll stability control [RSC] only)
-
System check
-
Units (English/metric)
-
Language
-
Autolamp
-
Autolock
-
Auto-unlock
-
Parking aid
-
Oil life start value
Setup Displays (High Series Instrument Cluster)
The setup displays are timed modes and terminate after a finite interval. Press the SETUP button for the following displays:
-
AWD lock (vehicles equipped with traction control with roll stability control [RSC] only)
-
System check
-
Units (English/metric)
-
Language
-
Autolamp
-
Autolock
-
Auto-unlock
-
Running boards (if equipped)
-
Easy entry/exit seat
-
Parking aid
-
Compass zone
-
Compass calibration
-
Oil life start value
System Check Displays
Selecting this function from the SETUP MENU causes the message center to cycle through each of the systems being monitored. For each of the
monitored systems, the message center indicates either an OK message or a warning message for 2 seconds. For base instrument clusters, the
TRIP/RESET button must be held down after pressing the TRIP/RESET button to cycle the messages through each of the systems being monitored.
For high series instrument clusters, pressing the RESET control switch cycles the message center through each of the systems being monitored. The
system check report is as follows:
-
OIL LIFE RESET
-
CHARGING SYSTEM
-
WASHER FLUID
-
DOOR AJAR
-
EXTERIOR LAMPS
-
BRAKE FLUID LEVEL
-
PARK BRAKE
-
FUEL LEVEL
