Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
Body Support - Number 3 (Explorer Sport Trac)
CAUTION: When removing upper body mounts, enough adjacent body mount support bolts and nuts must removed to prevent damage
occurring to the vehicle.
NOTE:
-
Body mounts must be held with a wrench on the bottom while loosening the bolt from the top.
-
Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.
-
No lubricants of any kind are to be used during body mount support installation.
Explorer and Mountaineer only
1. Remove the rear seat.
2. Remove the B-pillar trim panel.
Explorer Sport Trac only
3. Remove the scuff plate trim panels.
4. Remove the cowl side trim panels.
All vehicles
5. Position the carpet aside and remove the body insulator plug button.
6. Remove the body support bolt.
-
To install, tighten to 90 Nm (66 lb-ft).
7. Remove the body support washer.
Explorer and Mountaineer only
