Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
3. NOTE: You must carry out the RH and LH camshaft timing procedure when either camshaft is serviced.
Rotate the crankshaft clockwise to position the No. 1 cylinder at top dead center (TDC).
4. CAUTION: Do not rotate the engine counterclockwise. Rotating the engine counterclockwise will result in incorrect timing of the engine.
NOTE: The special tool must be installed on the damper and should contact the engine block. This positions the piston at TDC.
Install the special tool.
RH side
5. Remove the RH hydraulic timing chain tensioner.
6. Install the special tools on the rear of the RH cylinder head and tighten the top 2 clamp bolts to 10 Nm (89 inch lbs.).
