Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
2. Measure the telescoping gauge with a micrometer. Verify the diameter is within specification.
^
If out of specification, install new components as necessary.
Connecting Rod Cleaning
Connecting Rod Cleaning
CAUTION: Do not use a caustic cleaning solution or damage to connecting rods can occur.
1. NOTE: The connecting rod large end is a matched set. The connecting rod cap must be installed on the original connecting rod in the original
position. Do not reverse the cap. Parts are not interchangeable.
Mark and separate the parts and clean with solvent. Clean the oil passages.
Connecting Rod Large End Bore
Connecting Rod Large End Bore
1. Tighten the bolts to specification, then measure the bore in 2 directions. The difference is the connecting rod bore out-of-round. Verify the
out-of-round is within specification.
^
If out of specification, install new components as necessary.
