Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
Accumulator HVAC: Service and Repair
Suction Accumulator to Compressor Line
SUCTION ACCUMULATOR TO COMPRESSOR LINE
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Recover the refrigerant.
3. Remove the compressor suction fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (11 lb-ft).
4. Release the brake booster vacuum hose clamp and disconnect the hose.
5. Remove the suction accumulator-to-compressor line bracket bolt at the dash panel.
-
To install, tighten to 11 Nm (8 lb-ft).
6. Remove the suction accumulator outlet fitting nut.
-
To install, tighten to 8 Nm (71 lb-in).
7. Disconnect the auxiliary evaporator outlet line fitting (if equipped).
-
Discard the O-ring seals.
