Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
10. Disconnect the 2 vacuum connectors.
11. Detach the grommet and push the vacuum lines into the passenger compartment.
12. Remove the 4 heater core and evaporator core housing nuts.
-
To install, tighten to 9 Nm (80 lb-in).
13. Disconnect the ground terminal bolt.
14. Remove the heater core and evaporator core housing.
15. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
16. Fill and the engine cooling system.
17. Evacuate, leak test and charge the refrigerant system.
