Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
13. Add 0.5L (1 pt) of transmission fluid into the fluid pan. Stop the process by releasing the air pressure and removing the air nozzle from the end of
the hose.
14. Inspect the fluid level in the special tool. If the fluid drains back into the canister, the transmission is full. If no fluid drains back, more fluid will
need to be added. Repeat Steps 12 and 13.
15. Once the transmission is full, place a hand vacuum pump on the open end of the vacuum/pressure hose on the special tool and apply vacuum to the
system. This will pull out any extra fluid trapped in the system and direct it into the container.
16. Allow the fluid to drain. Make sure that the fluid temperature is between 27 - 49°C (80 - 120°F). When the fluid comes out as a thin stream or
drip, the fluid is at the correct level.
17. Reinstall the small (center) fluid level indicating plug using a 3/16-inch Allen key.
^
Tighten to 10 Nm (89 inch lbs.)
18. Check the operation of the transmission by moving the range selector lever slowly through each gear, stopping in each position and allowing the
transmission to engage.
