Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
10. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is
snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the selector lever
cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull
back on the selector lever cable end to make sure that the cable end is correctly installed.
Install the selector lever cable end onto the manual control lever.
11. Reconnect the digital TR sensor electrical connector.
12. Move the rubber boot back over the connector.
13. NOTE: If the shield is loose on the cable, replace the shield.
Install the cable shield.
