Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
1. Position the seat so it does not engage the safety belt buckle and pretensioner bracket and allows access to all 4 seat-to-floor fasteners.
2. Remove the affected seat and depower the SRS.
3. Remove the safety belt buckle pretensioner electrical connector cover.
4. Disconnect the safety belt buckle electrical connectors.
5. Remove the 2 nuts and safety belt buckle pretensioner.
-
To install, tighten to 36 Nm (27 lb-ft).
6. To install, reverse the removal procedure.
7. Install the affected seat and repower the SRS. If the passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
8. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS. See: Air Bag Systems/Testing and
Inspection/Component Tests and General Diagnostics/Occupant Classification Sensor (OCS) System Zero Seat Weight Test
All seats
9. Check the active restraint system for correct operation.
