Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
Explorer/Mountaineer and Explorer Sport Trac with 60/40 bench seat
1. Remove the appropriate 60 percent or 40 percent bench seat.
Explorer Sport Trac
2. Remove the rear trim panels.
Explorer/Mountaineer with 60/40 E-Z entry seat
3. Tilt the headrest to the E-Z entry position.
4. Fold the appropriate seat and tilt FORWARD to the E-Z entry position.
Explorer/Mountaineer with 60/40 E-Z entry and bench seat
5. Remove the upper C-trim pillar panel.
6. Position the rear quarter trim panel aside to access the safety belt retractor.
All vehicles
7. Remove the bolt and safety belt retractor anchor.
-
To install, tighten to 40 Nm (30 lb-ft).
8. Remove the bolt and D-ring.
-
To install, tighten to 40 Nm (30 lb-ft).
9. Remove the bolt and safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
10. To install, reverse the removal procedure.
11. Check the active restraint system for correct operation.