Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
Suspension Spring ( Coil / Leaf ): Removal and Replacement
Shock Absorber and Spring Assembly
Shock Absorber and Spring Assembly
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in
major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement
part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of
these parts.
1. Remove the lower arm.
2. Remove and discard the 3 shock absorber upper mount nuts and remove the shock absorber and spring assembly.
^
To install, tighten to 30 Nm (22 ft. lbs.)
3. For additional information on the disassembly and assembly of the shock absorber and spring assembly, refer to Shock Absorber and Spring
Assembly.
4. To install, reverse the removal procedure.
