Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
Wheel Bearing: Service and Repair
Front
Wheel Bearing and Wheel Hub
Special Tool(s)
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can
result in major service expense. A new part with the same part number or an equivalent part must be installed, if installation is necessary. Do
not use a part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct
retention of these parts.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove and discard the halfshaft nut and washer.
^
To install, tighten to 250 Nm (184 ft. lbs.)
3. Using the special tool, separate the outboard CV joint from the wheel hub.
