Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
7. Apply a maximum of 206.85 kPa (30 psi) to the open end of the vacuum/pressure hose from the special tool. Fluid will immediately start flowing
out of the special tool into the transmission fluid pan.
8. Add 1.89L or 2.83L (2 qt or 3 qt) of transmission fluid into the fluid pan. Stop the process by releasing the air pressure and removing the air
nozzle from the end of the hose.
9. NOTE: Engine idle speed is approximately 650 rpm.
Using the scan tool, start and run the engine until the transmission fluid temperature is between 27°C - 49°C (80°F - 120°F).
10. Inspect the fluid level in the special tool. If the fluid drains back into the canister, the transmission is full. If no fluid drains back, more fluid will
need to be added. Repeat Steps 9 and 10.
11. Once the transmission is full, place a hand vacuum pump on the open end of the vacuum/pressure hose on the special tool and apply vacuum to the
system. This will pull out any extra fluid trapped in the system and direct it into the container.
12. Allow the fluid to drain. When the fluid comes out as a thin stream or drip, the fluid is at the correct level.
