Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
8. CAUTION: To prevent interference with the rear disc brake caliper operation, install only the correct disc brake caliper bolt.
NOTE: Make sure the stainless steel shoe slippers are correctly positioned. Install new slippers if worn or damaged.
NOTE: Use the brake disc pad spreader to spread pads for reassembly.
Install the disc brake caliper, then install the disc brake caliper bolts.
^
Tighten to 32 Nm (24 ft. lbs.)
9. CAUTION: The driveshaft centering socket yoke fits tightly on the pinion flange pilot. To make sure that the yoke seats squarely on the
pinion flange, tighten the driveshaft flange bolts evenly in a cross-pattern as shown.
CAUTION: If new driveshaft flange bolts are not available, coat the threads of the original driveshaft flange bolts with Threadlock and
sealer.
Install the driveshaft, then the driveshaft flange bolts.
^
Tighten the bolts in the order shown to 112 Nm (83 ft. lbs.)
10. Install the rear wheel and tire assemblies.
Stub Shaft Pilot Bearing and Seal
Stub Shaft Pilot Bearing and Seal
