Explorer Sport Trac 4WD V6-4.0L VIN K Flex Fuel (2004)
3
Connect the power lumbar motor electrical connector.
13. Install the screw into the power lumbar motor and install the J-clip.
All vehicles
14. Install the seat cushion frame.
1
Position the seat cushion frame.
2
Hook the seat cushion trim cover J-clips.
15. Connect the seat backrest recliner actuator.
1
Connect the seat backrest recliner actuator.
2
Install the screws.
-
Tighten until the screws are fully seated.
16. Install the seat cushion.
40 Percent
REAR SEAT CUSHION - 40 PERCENT
DISASSEMBLY
1. Remove the rear seat.
