Explorer Sport Trac 4WD V6-4.0L VIN K Flex Fuel (2004)
4. Using the special tool, remove the crankshaft pulley.
Installation
1. NOTE: If not secured within four minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing area, use silicone
gasket remover and metal surface prep. Follow the directions on the packaging. Failure to follow this procedure can cause future oil leakage.
Apply silicone gasket and sealant to the Woodruff key slot on the crankshaft pulley.
2. Using the special tool, install the crankshaft pulley.
3. Using the special tool, install a new crankshaft pulley bolt.
^
Tighten the bolt in two stages:
^
Stage 1: Tighten the bolt to 50 Nm (37 ft. lbs.).
^
Stage 2: Tighten the bolt an additional 90 degrees.
4. Install the accessory drive belt.
5. Install the fan shroud.
